The owner of this Stejcraft contacted us about a serious crack in one of the spray rails that was allowing water into the hull. As the owner was located outside our service area and unable to bring the boat in initially, we provided an estimated repair cost based on photographs supplied to us. Once the […]
EVA Foam pads for custom Wake Boat – EVA Foam Decking Medowie NSW
We recently machined some pads for a customer with a wake boat, including a custom logo on the swim platform. These pads will be fitted by the owner who also supplied the templates. We look forward to seeing photos of these once fitted!
Jetski Hull Repairs and custom EVA foam panels – Jetski Repairs Medowie NSW
The owner of this Wave Runner ski suffered some nasty hull damage from grounding. He also asked for a touch-up on the deck and some custom EVA panels fitted for when he loads his surfboards in the footwells. For the hull work, the ski was lifted onto work stands and the hull bottom repaired.
Custom Centre Console Haines gets some finishing work! Boat Repairs Medowie NSW
Some may remember this boat being in for some other work a few months ago. We built a custom engine well and bait tank design in the back area which had been left unfinished after the original mods were done. The owner has done the painting on this boat since then and asked us to […]
Haines 600R Rebuild – Boat Hull Rebuilds Lemon Tree Passage NSW
This Haines 600R externally was in very good and original condition, however internally nearly all the plywood parts were rotten. The owner first approached us about a few mods, starting with a new wave breaker, also a couple of custom inbuilt bait tanks and some cosmetic work. Unfortunately when he was doing some work on […]
Bertram 25 Engine Beds – Boat Repairs & Modifications Port Stephens NSW
We helped this customer reconfigure his Bertram 25 from twin engine installation to single. This entailed cutting out the old (rotted) twin engine beds, replacing this structure and installing new engine beds to suit the new Volvo inboard stern-drive engine. Internally not only did we discover that the old engine beds were rotted but also […]
Chase Custom Swim Platforms – Boat Modifications Medowie NSW
We were asked if a pair of swim platforms could be added to this American made Chase 580. Almost anything can be done with modern composites and this was no exception. Although the mounting surface on the stern of this boat was a complex shape requiring the surface to be prepped with mould release and […]
Update on 40ft Catamaran Refit – Boat Modifications Medowie NSW
Another update on this catamaran refit, the hardtop is structurally built with new foam/epoxy front supports and inbuilt bolt rope track for clears. All wiring has been run inside the structure for lights and solar panels. The main sheet system has been moved onto the back of the hardtop with composite support posts glassed in […]