This tidy Stacer was suffering the usual fight with corrosion and had blistering paint areas scattered around it, mostly above the gunnel line. After agreeing on the number of repairs these were ground back to metal and etch primed. Following this we epoxy primed the areas and prepped for painting. With so many spots on […]
High speed Jetskis can often cause damage to the hull without even realizing it. This Waverunner hit hard and the damage was through the hull skin with another area behind this. As with these jobs the ski is lifted onto work stands for access and the damage is repaired using epoxy and then refinished. Because […]
This Seadoo was only 2 weeks old when the damage occurred! The finish was a metallic pearl and required some careful colour matching but the result was spot on.
It’s common to see older style boats that have been sitting for some years. This 6m Fraser Formula is a well-loved family treasure that was in desperate need of some TLC. The white gelcoat condition wasn’t too bad and could be brought back up with a good cut & polish however the blue panels were […]
Black is always the most difficult colour to repair. Although it seems to be a very common colour for late model Jetski’s and we have done many over the years. From full resprays, partial resprays and spot repairs. Note the one in earlier post just last month. This Ski had deep hull damage near the […]
We were called to refurbish this teak bowsprit on this 52ft Flybridge Sport Fisher. Once started on the brightwork we found that the stainless skid plate for the anchor had delaminated and was buckling up when the anchor was stowed. After the varnish work was completed we Sikaflexed this back down again and weighted it […]
This Lewis ski boat had peeling clear coat coming off in sheets. Luckily most of the affected areas were above the gunnel. There were a couple of bad areas on the stern which were able to be touched up. We were careful to ensure all the old clear was removed to be sure it wouldn’t […]
This Caribbean had an unfortunate accident with the corner of a jetty. The tide caught the boat side on to a jetty and the force of the current cracked the hull topside panel. The damaged area was prepped and glassed in epoxy for maximum strength and then faired and primed. The finish coat was done […]