This net boat was converted to a day boat style concept by it’s owner. However the project had been sitting idle for some time and we were requested to complete the work. The boat needed the cabin top fitted and glassed, floorboards made, an extra window cut, windows fitted and inside and out to gunnel […]
We were asked to supply a quote to replace one of the keels on this catamaran. When the boat was lifted it was discovered that both keels were missing. How the keels were lost is a mystery as the owner was not aware of anything at the time. The original keels were built as a […]
This job started off with a relatively simple repair to the stern drive mounting hole however the job list soon grew. The owner requested some exhaust fittings removed and re-fitted on the transom. This involved removing the duckboard assembly for access and some re-finishing work. Also one of the engine beds needed repairs and re-flowcoating.
The owner of this inflatable tender brought this in for repairs on the rigid fiberglass hull bottom. These are built in two sections, a top and a bottom, glued along a flange. The flange joint had delaminated allowing water into ther hull. At first the idea was to simply prise the joint open and re-bond a […]
It doesn’t have to be a boat to involve fiberglass repair work. These sewerage treatment pipes were in need of repairs in high load areas. These were made in a split mould with the inside surface being smooth. The repairs were carried out using epoxy for maximum strength and durability. The customer didn’t want to have […]
This US import has been to us before for hull repairs. The first job we did was repairing cracked planing strakes which were taking on water. After this work it was recommended to the owner to have a flexible section of the hull below the kill pens reinforced with foam and epoxy laminated stiffeners. To […]
We took on this project the owner had started but had been sitting for some time. The owner had fitted the new plywood and done some of the prep work. We glued in the plywood with epoxy glue and re-laminated the face including over the edge of the transom into the wet well. We were […]
This water tank had a hole in it and needed to fiberglassed to repair and seal. We ground the area to prepare and then glassed inside and out for a quality repair.