This is another update on this ongoing project, we are now working on the finishing work to complete this vessel. To remind followers, this vessel was cad modelled and cut as a kit from Coosa composite board, and then has been assembled/built in epoxy. Following on from the previous post, we have now installed the deck and superstructure, the drive shaft and rudder tubes, engine bay fit-out and window frames. The underwater has been painted in gloss black. We have also painted the interior with Raptor liner and prepped the exterior for painting. Most of the deck hardware has been prefitted including the twin anchor winches and hawse pipes. Below the winches we have fitted custom chain bins to catch the chain. The internal doors and lockers have also been fitted. With not long to go we will keep everyone updated when this project is finished.